CASTLE EURO Especificaciones descargar pdf (Pagina 57)

Castle Care-Tech Ltd. Engineering

Page 10 - 4 Chapter 10

G: POWER

-

UP INITIALISATION

Pre Power-Up Checks

Prior to powering up the

system, a final check should be

made of:

1. POWER SUPPLIES – adequate

for the load to be applied.

2. WIRING – conforms to

specifications in this

manual (see 4-4, 11-2).

3. CONNECTIONS – correctly

made, with no loose

‘whiskers,’ etc.

When you are satisfied that all

is correct:

Powering Up

Power up the End Station on

MAINS ONLY.

Go to the first keypad, which

will be showing

ADDRESS

[- -]

Key

00

and

A

Euro-MERiDIAN

Time: 00:05

The system will be generating a

tamper alarm, use default code

(1234) to silence. When

‘Battery Fault’ is indicated (NOT

BEFORE), the back-up battery

should be connected.

Additional keypads on the

system must also be addressed

in the same way, ensuring that

no address duplicates another

Keypad, Tag Reader or Access

Control Point.

When this has been done, any

additional power supplies may

be powered up – noting the

same need to await a ‘Battery

Fault’ indication before

connecting the back-up

battery.

NOTES:

A blank keypad display may mean

that it has previously been coded

to an address other than 00 (eg

for test purposes). Press the

'D' key for 10 seconds to

access the menu to enter the

correct address as above. When

prompted to enter a code, this is

‘2000.’

Additional keypads, and any tag

readers on the system will NOT

work unless they are correctly

addressed,

AND enabled in the

engineer menu, as shown on page

12-3.

Voltage Measurements:

Please note that on initial

power up, at mains restore,

and on exit from engineering,

the PSU voltage will initially

vary according to the state of

battery charge. Measurements

at these times may therefore

be misleading.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 197 198

Comentarios a estos manuales

Chrisaroks 29 Apr 2024 | 00:45:00

Hello, im noob :)