CASTLE EURO Especificaciones descargar pdf (Pagina 52)

Manual Euro-MERiDIAN

Chapter 9 Page 9 - 9

e) Additional Facilities

Additional facilities are

available for use in conjunction

with Sequential Confirmation

signalling, as follows:

(i) 'Entry Shock' zone type:

Patent applied for.

This zone type is always used in

conjunction with a 'Final Exit'

zone. The 'FX' zone is a door

contact on the initial entry

door, and the 'Entry Shock'

zone is a non-latching shock

sensor fitted to the door frame

in the vicinity of the lock.

If the initial entry door is

subject to gross attack and

forced open, then at the expiry

of entry time only one further

intruder zone needs to be

tripped to signal a sequentially

confirmed alarm - counting the

'Entry Shock' zone as the first

to alarm..

Triggering the Entry Shock

zone in isolation will NOT

generate an alarm of any kind.

The Final Exit door contact

must be opened within 10

seconds of the shock detector

triggering for the Entry Shock

response to apply.

This configuration thus

provides enhanced protection

for forced entry via the entry

route as an alternative to the

'shunt lock' option.

CAUTION:

The 'Entry Shock' function should

only be used after careful risk

assessment. It is essential that

the shock detector is properly

adjusted, and that the door

construction / fittings are

adequate for the purpose.

(ii) 'Confirm Group' zone

attribute

Applying this attribute to any

zone will prevent a zone from

confirming an alarm triggered

by another zone within the

same group.

Thus if a number of detectors

are in use that could respond

to the same stimulus (eg

multiple shock or pressure

wave detectors), these may be

wired individually to the

control to avoid the need for

complex 'series' wiring.

NOTE: Default allocation "00"

means that zone is NOT allocated

to a group.

Zones allocated to Group "99" will

trigger a first (unconfirmed) alarm

in the normal way, but will NEVER

trigger a 'confirmed' signal,

regardless of which group the

'first alarm' zone is allocated to.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 197 198

Comentarios a estos manuales

Chrisaroks 29 Apr 2024 | 00:45:00

Hello, im noob :)