CASTLE EURO Especificaciones descargar pdf (Pagina 46)

Manual Euro-MERiDIAN

Chapter 9 Page 9 - 3

arm Isolates’ (in ‘SITE OPTIONS’)

is selected, in which case the

zone will remain isolated until

manually reset (unless it is a

‘Final Exit’ zone).

Misoperation (Abort)

Signalling

May be signalled:

A: By dedicated

‘Misoperation’ signal

B: By generation of the

‘unset’ signal

All these options will be

signalled (if programmed) when

a valid user code is entered

after the generation of the

‘intruder’ signal. There is no

time limit on this.

Note that 'intruder' signal will

restore if the system is reinstated

after an unconfirmed alarm.

‘Misoperation’ can optionally

be signalled when silencing an

alarm at a ‘Ward Controller.’

Engineer Reset

Separately programmable for

‘PA’‘Intruder,’'Confirmed' and

‘Tamper’ alarms, also for ‘soak’

zones triggering falsely. If

programmed, this becomes

valid immediately the

appropriate alarm output has

been generated.

NOTE: If audio or visual

confirmation systems are in use,

'engineer reset at confirmation'

will apply only when sequential

confirmation is valid.

Reset may be performed:

A: By use of the Engineer

code (even if another

area remains set)

B: By use of the ‘Red Care’

reset facility (see below).

C: By use of a remote reset

code generated at the

ARC from an ‘anticode’

generated by the system.

D: By ‘download from Euro-

InSite software.

Engineer Reset of Intruder may

be selected as operative when

using standard ‘Intruder’

output signalling, or for ‘Secure

Intruder’ signalling.

Digi Reply Signal

An input is available through

the ‘STU connections’ to accept

an input signal from the Alarm

Receiving Centre.

This may be programmed (in

‘SITE OPTIONS’) as:

‘None’ when not to be used.

‘Fail to Communicate' for

use with a digital

communicator (to log

the failure to receive

acknowledgement of

the signal from ARC).

‘Red Care Reset’ to accept an

‘Engineer Reset’ signal

from the ARC.

‘Relay’ provides monitoring

of the ‘plug-on’ relay

interface (non-UK use).

NOTE: If 'None' or 'Relay' is

selected, monitoring of the inputs

will NOT be active.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 197 198

Comentarios a estos manuales

Chrisaroks 29 Apr 2024 | 00:45:00

Hello, im noob :)