CASTLE EURO Especificaciones descargar pdf (Pagina 37)

Castle Care-Tech Ltd. Engineering

Page 6 - 2 Chapter 6

d) Backlighting

LCDs and Keypad keys are

backlit. The backlighting will

illuminate at the start of entry

and exit times, and at key (or

tag) entry, and will remain lit

for 30 seconds after the last key

entry, or termination of the

function.

NOTE: An option is available at each

keypad to force the backlight to remain

lit except in mains failure, see 12.3.

e) Fault Indications

Fault indications shown on the

Liquid Crystal Display will

include a numeric

identification of the individual

device at which the fault is

present, eg

Mains Failure 401

Device Failure 214 etc.

The first digit identifies the

device type:

1 = End Station

2 = Keypad

3 = Tag Reader

4 = Zone Expansion Module

5 = Output Module

The remaining digit(s) identify

the individual device of the

type, thus

Mains Failure 401 - identifies

the Zone Expansion

Module addressed as 01

etc.

For details of other fault

indications, see Appendix A.

f) Engineer Reset

If the system indicates

‘Engineer Reset Required’ (see

‘Site Options’), this must be

performed before the area(s)

on the system to which it

applies can be used again. The

reset may be performed:

a) By entering the engineer

code. The system will not

enter the engineer mode,

but will reset.

b) By entering the special

reset code derived from

the displayed ‘anticode,’ by

means of the Castle ‘

Remote

Reset Code

’ programme.

c) By the ‘RedCare Reset’ line

being activated via a ‘STU’

d) By ‘Download Reset’ from a

PC running Euro-InSite

software.

The system will log the reset,

however initiated.

The entire system must be

unset before an Engineer Reset

may be performed.

Note: by default, engineer reset of

Intruder alarms will be invoked

when an intruder/confirmation

signal is triggered after the

system is set. If ‘secure intruder’

signals are used (which signal also

during exit time), a Site Option is

available to invoke Engineer Reset

in this mode also.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 197 198

Comentarios a estos manuales

Chrisaroks 29 Apr 2024 | 00:45:00

Hello, im noob :)