CASTLE EURO Manual de instalación descargar pdf (Pagina 49)

Programming Manual EURO

RINS1291-3 Page: 49

Test Siren?

To Test the Siren press the key.

All outputs programmed as either Siren or

Strobe will be tested. ‘Testing Siren’ will be

displayed. Press the  key to stop the test.

‘Test Siren’ will be displayed, press the 

key.

Do Battery Load Test?

To perform a Battery Load Test, press the

key. The Battery Load test will be

started. Once the Battery test has

completed, press the key, ‘Do Battery

Load Test’ will be displayed, press the 

key.

Test Outputs?

This tests all the outputs on the control panel

(including outputs on ZEMs, Output Modules,

and ATE pins) To test the outputs press the

key. Select the Output type you would

like to test (see page 35 for the output

types) and press the key.

All outputs programmed as the type selected

will be active. Press the  key. The

outputs will switch off. Repeat for other

output types as required. Press the  key.

‘Test outputs’ will be displayed. Press the

 key. You will be returned to the Engineer

Menu.

Test CHC Communications

If you are using SMS, you need to send a

test signal to the Castle Host Computer.

Press . ‘Test Complete’ will be displayed

after a couple of minutes. Press 

Test SIA/CID Communications

If you would like to test SIA or Contact ID

communications, press and a test signal

will be sent to the ARC. Press 

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 67 68

Comentarios a estos manuales

Sin comentarios