CASTLE EURO Manual de instalación descargar pdf (Pagina 17)

Programming Manual EURO

RINS1291-3 Page: 17

*Special Log

Forces a log entry when the input is opened or closed, even when an alarm

does not result. May be selected to apply when a system is set, when unset,

or always.

*Paired

Input

For use in Grade 3 iD systems (or EoL inputs on peripheral devices fitted

software prior to version 5). Select to ‘YES’ for each of the two biscuits

acting as the input. Fault Input: Select to ‘YES’ for the biscuit acting as the

‘fault & anti-mask’ Paired With: For both biscuits enter the input number

with which each is paired.

Confirm

Group

If one or more inputs are selected within the same confirm group, all

confirmed signals will be disabled. If confirm group is selected as ‘00’ the

inputs are not part of any group. If inputs are allocated to group 99 they will

generate an alarm that results in an intruder (unconfirmed) signal to an ARC.

They will not under any circumstances generate a confirmed signal,

regardless of which group the input that selected the ‘unconfirmed’ alarm is

allocated to.

*These are not available on the EURO 28. All attributes are disabled at default.

Any input may be programmed with any combination of these attributes, except where stated.

4.6.5 Masking Response

When unset, a masking event will generate an audible “alert” that requires response in the

normal way. There will be NO signal transmitted to the ARC. When set, a masking event will

generate a normal ‘intrusion’ response including “intruder” or “unconfirmed” output, but will

NOT result in a confirmed alarm if paired with a normal activation of the same detector. This

harmonises with the requirement of EN50131-1 cause 8.4.5 and the insurer’s preference

expressed in BSIA Form 171.

4.6.6 Automatic Inhibit of Inputs

Inputs may be automatically inhibited (omitted) at the time of reinstatement at the end of

confirmation time. The number of times that this takes place is controlled by the “Re-Arm

Number” in the timers section. See page: 27.

Change Inputs

Using the and keys, scroll to

‘CHANGE INPUTS?’. Press the key

Input

Select the input number you wish to program

and press the  key.

Input Type

Select the input type (See the ‘input types’

table – Page: 14) by using either the

numeric code or the andkeys.

Press the  key.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 67 68

Comentarios a estos manuales

Sin comentarios

CASTLE EURO Manual de instalación Pagina 17

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad CASTLE EURO