CASTLE Meridian Especificaciones descargar pdf (Pagina 7)

Started Manual Castle Care-Tech Ltd

5·00 Page 13

Mount all detectors in the

required locations, and wire

them to the iD bus in any parallel

configuration

– parallel, spur or

star

– as above.

NORMALLY OPEN DETECTORS

should be connected in the same

way, with the ‘Normally Open’

attribute selected when

programming the input.

For input number identification,

refer page 27,28.

iD LINE TERMINATION

Each cable run should be

terminated with a 0.01µF

capacitor connected between iD

+ and - (yellow and blue) at the

last biscuit

Reminders for successful

installation of an iD system:

1. Ensure that all biscuits are

correctly connected

2. Do not mix iD and iD Plus

biscuits

3. Ensure that safe wiring

distances are not exceeded and

cable runs are correctly

terminated (0.01µF capacitor).

4. Ensure that all biscuits are

wired directly to the detector

5. Ensure that cabling

specifications are carefully

followed (see page 8).

6. Ensure that the resistance

measurements are correctly

checked and recorded.

If you are not familiar with iD

wiring, please request Technical

Note “Installing iD Systems” for

additional information

.

Note on Programming Biscuits

for Grade 3 systems:

Paired Input?

Yes [1]

When programming both

biscuit 1 and 2 (see page 12),

set this to yes.

Fault Input?

No [0]

If programming biscuit 2,

the biscuit connected to the

mask/fault terminals of the

detector, set this to ‘yes’,

otherwise leave at ‘no’.

Paired With?

Enter the input number of

the biscuit you are pairing

with (for each input of the

pair), e.g. if programming

biscuit 2, enter the input

number of biscuit 1.

Castle Care-Tech Ltd Euro-MERiDIAN Getting

Page 14 Software

7. WIRING OUTPUTS

When wiring outputs, do not exceed the maximum rating

for individual outputs, or the system power supply.

SAB Connections

OUTPUT RATING

Strobe and Siren Outputs are

rated for 800mA each. Note

that the 'Hold Off' fuse is rated

as 800mA.

Ensure that the system

power supply is not

overloaded.

Other End Station Outputs

Current Available

:

Speaker:

500mA

Output 3:

100mA

Output 4:

100mA

NOTE: Output 3 may also be

used at relay terminals ‘A’ on

Euro-G3+. Select jumper JP1

at left, linking pins 1 and 2

Current Available

:

O/p 1 (siren):

800mA

O/p 2 (strobe):

800mA

Hold Off:

800mA

Note

tamper return

is NEGATIVE.

1 2 3 4 5 6 7 8 9 10 11 12 ... 26 27

Comentarios a estos manuales

Sin comentarios